Doors: How to replace an internal door knob
Remove the door from its hinges by driving the hinge pins through the bottom of the hinge with a hammer and a screwdriver Start with the bottom hinge and work to prevent tilting of the door Lay the door flat on a pair of sawhorses .
Sand the affected area with 150 grit sandpaper on a random orbital sander include the area directly surrounding the damage, as well.
Fill dents or recesses of the door with the paste solvent-based wood colored doors or body filler putty painted doors Use a soft putty knife to distribute uniformly charge in the damaged area, leaving raised a little from the face of the door Leave charging stand for 30 minutes.
Sand of the smooth surface using 150 grit paper wipe dust from the surface with a cloth dampened with mineral spirits.
Apply two coats with a brush with soft paint hair with or a corresponding layer finishing spot all-in-one to paint the damaged area in long straight lines, with attention on the wooden doors or vertically on the door face Expect smooth the manufacturer's recommended between coats and before the new hanging door.
Hang door aligning hinge halves and the drive pin downwardly into the hinges, starting with the top hinge.
Remove the screws from the hinge jamb side with a cordless drill starting from the bottom and work your way to the door Lay flat on a pair of saw horses.
How to repair the water damage to the bottom of a wooden door with the sealing water.
Tighten the hinges that are loose in the edge of the door with a screwdriver Replace stripped overlooked 1 of 2 inches longer than the original.
Driving the hinge pins with a screwdriver and a hammer to separate hinge halves Replace the side plates of casing into the mortises in the jamb drive a 3-inch screw through each hole in the hinge plates through the doorframe in the rear frame to anchor the hinges.
Place the door vertically align the hinge halves and cause the rods down into the hinges at the top, from the top hinge and working downwards.
Test the door for proper operation to correct any sagging by tightening the top screw on the top hinge with a cordless drill to lift the door slightly tighten the remaining screws accordingly.
How to repair a damaged door eHow, repair, damaged, door, door pair flat.